I just don't have space enough in my workshop, so I have set up a small dedicated table/drawer with a perfect hight for fretting and electronics.. The top is actual too small, but I can't make it bigger because of two doors. I have always been afraid to drop a guitar on the floor by accident.
I "kind of" solved it this way. I drilled 2 long holes into the top for 2 long alu rods, and connected the with a piece of wood. On that piece, I made a sledge, that holds a bolt with a top that fit a neck curvature. The bolt is grinded flat on top, and screwed onto a piece of heavy plastic, (could be wood). The pieces are covered with felt. The sledge has one bolt for adjusting both hight and sidewards position. The whole arrangement can be slided out, so it extends my work area. This makes any operation much more safe.
Neck jig for limited space
Moderator: jhg
- pp-guitars
- Holzkäufer
- Beiträge: 132
- Registriert: 20.09.2011, 11:22
- Wohnort: Middelfart, Dänemark
- Hat sich bedankt: 2 Mal
- Danksagung erhalten: 2 Mal
- pinacoco
- Halsbauer
- Beiträge: 318
- Registriert: 18.06.2013, 14:30
- Wohnort: Winnenden
- Hat sich bedankt: 0
- Danksagung erhalten: 2 Mal
- Kontaktdaten:
Re: Neck jig for limited space
Pretty good idea, thanx for sharing.
Gruß
Uli
-------------------
Hör nie auf anzufangen, fang nie an aufzuhören.
Uli
-------------------
Hör nie auf anzufangen, fang nie an aufzuhören.
- sunrisebrasil
- Ober-Fräser
- Beiträge: 766
- Registriert: 11.08.2013, 06:27
- Wohnort: 71334 Waiblingen
- Hat sich bedankt: 8 Mal
- Danksagung erhalten: 8 Mal
- thoto
- Luthier
- Beiträge: 3219
- Registriert: 09.10.2013, 12:33
- Wohnort: Braunschweig / Niedersachsen
- Hat sich bedankt: 545 Mal
- Danksagung erhalten: 525 Mal
Wer ist online?
Mitglieder in diesem Forum: 0 Mitglieder und 23 Gäste